Видео

Do you screw cap down to check oil?? Or just set it down without screwing it in?

Maintenance for this engine is really nuts. Need to adjust valve settings? What kind of POS engine is this? that's way beyond maintenance. That's periodic engine rebuild

He used 2 open end wrenches to tighten the drain plug to 61 inch pounds?! What? No torque wrench available? Ha!

No mention of the size of wrench to take the plug off

I can't find any information on the Kawasaki fx691v engine can you recommend a video explaining these engines, i have one on my new zero turn that i don't get for another 2 weeks

So how do you replace the shitty plastic drain valve when it melts out, and there is not enough clearance to thread in the replacement one?

I have a fs730v efi 180hrs valve seal spring missing lots of smoke at start up John Deere replaced the seal spring however where is the spring? in the engine? if it is will the filter catch it before it reaches the oil pump?

2020 Kawasaki blew up with less than 100 hours do to faulty air filter. Won't honor warranty. You will find out all about Kawasaki when you try to deal with them They blow you off and then ignore you. Never again, stick with Honda or Kolher. They stand behind their products.

Engine blew up with less than 100 hours do to air filter they installed. They won't honor warranty and won't talk with you. Never again. Buy Honda

Kawi engine blew up with less than 100 hours. Won't honor warranty. Good luck getting someone to talk with you. They just blow you off. Never again. Buy honda

Engine last less that 100 hours and Kawasaki won't honor their warranty. You are a fool to by Kawasaki

What is the oil gas mix for rh600s? Thank you 🙏

That part where the drain plug just twisted right off must be CGI.

Do all kawasaki engines use the same tune up kit?

Help me with the site to buy the tune up kit urgently for my husqvarna z254f, it runs on a kawasaki engine? I need everything in the kit listed in the video

I have a Kawasaki FX850V-CS21 engine. I keep finding from parts dealers on Amazon that the original oil filter 49065-7044 has been replaced by 49065-0724 is this true ?

Kohler 7000 series engines all day long over Kowalski engines

I'm confused. I just got an ariens ikon XD 42 with Kawasaki fr600 engine. Do I need to do an oil change a 5 or 10 or whatever hours as a break in oil change? Manual doesn't state it besides change at 100 hours

Fuel control switch

What is the initial break in period for the Kawasaki engines?

You should come back to the trimmer market I'm ready for a new one best product ever.

I have this exact mower and love the kawasaki engine. From my experience i would install a metal elbow coming from the engine to the rubber oil line out the back. Mine kinks from the 90 degree turn it has to make. That kink will eventually cause a hose fail for me one day.

My Kawasaki engine 730 V was backfiring bad from my Brand New..Husqvarna mower.. Parked in the garage and decided to check the spark plugs.. Found one plug .025 and the other at .026 manufacturer recommends .030.. the backfire was so loud it sounded like gun fire?.. did this ruin my brand new mower?. thanks.

like how they cut the scene where the oring was about to be a biatch.

Kawasaki is hands down the best lawn mower engine out there. I have a 93 and it still runs.

My Kawasaki FS 730 V is a royal pain in the balls to change the oil. Impossible to change the filter without getting oil all over the place. And I hate the drain valve also it's made of plastic and it started to leak after two years and I had to replace it. Not an easy chore .

where can I get one?????!!!!!

Too many parts, steps, adjustments; just buy a Echo Speed Trimmer Head!

what happened to the DFI ! haha

My Kawasaki won’t start until the oil is changed but I just changed it

On the 730 24 horse KAW motor my specs say to change for the first time at 25 hours, is that correct? Also to check the oil level do you screw the dip stick in all the way or just seat it then check? Thanks.

Yea, remember the Briggs scam lawsuit???

Is it really open loop? I'd think there'd be more of a safety margin and ability to run leaner and cleaner with a closed loop system utilizing an AFR sensor.

Sucks they longer sell these. Everyone buys echo or sthil etc. And they don't compare to the Kawi. They will last forever and run much cleaner than the others. I work on them and they were the best equipment and now gone.

Above 11 000 views and where is HD quality of this video???

The weedwacker starts a little rough when it's the first start of the day. Once it's warmed up, it starts instantly.

Dam fellers I need contact info for manuel or ph. # where I can buy the blasted thing , An Kawasaki site aint worth a crap either or the automated phone system either.

Why this video is not in HD. It's shame. Superior quality of Kawasaki products and poor quality of RUclips videos..

Very good piece of equipment!!! I tested it and I could work above 6 hours with minimum tiredness.. Low weight, quality and power!! Good job Kawasaki!

I wouldn't have any other engine on my mower! Kawasaki, the best out there!!

No drop off in speed while mowing? Awesome! I have an FS481V on my eXmark Metro and it idles at 3480 only and slows to 3360 under normal mowing conditions. It only ever idled at 3600 on the day I bought it.

ECHOalltheway...but kawasaki is still really good

is Kawasaki the only good brand in the world?

Hi I just want to say that I purchased a Cub Cadet with a FR691V Engine and It sounds great. one question How can I download a manual?